Plumbing work on the new house has moved to the supply lines with all of the drain and vent work now completed. I could not be happier with the workmanship. The main and guest bedrooms will have digitally controlled valves. These are the two black boxes on the right. A console in each shower area will control the valves allowing for selection between a rain head and a shower head, precise temperature control, user presets, and integration with our home automation system. “Hey Siri, start Carl’s shower.” My preset temperature and shower head combination will be selected and when the water reaches the set temperature the shower will pause until I enter. This feature is a little bit decadent but there are few things that I covet more than the relaxation derived from my morning shower. It is where I do my best thinking and relieve the aches and pains that seem to be the new normal as my age advances.
The manifold on the left includes hot (red) and cold (blue) supply line shutoffs for different sections of the house. The valve on the far left is for the outside water bibs and includes a purge valve for winterization.
The threat of snowfall from a powerful Nor’easter kept all but the plumbers from showing up at the River House today and they only worked until mid-morning. This gave me free run of the house to complete the ventilation distribution system for which I am the installer. What I enjoyed most was the peace and quiet. The subs invariably have their job site radio’s tuned to stations I do not particularly care for. The snow kept mixing with rain throughout the day which limited total accumulation to about 3 inches. Had it been one to two degrees colder, we could have easily seen three times that amount.
When designing the layout for the River House, I provisioned for a vertical chase behind the stairwell to accommodate the various mechanical systems of the house. It goes from the basement all the way to the roof line. At the time, I thought I had provided a generous amount of space. Now I am thankful that everything is just fitting (barely). The chase is occupied by the following items:
8″ round intake duct (ventilation system)
8″ round exhaust duct (ventilation system)
4″ radon vent
12″ x 8″ second floor heating/cooling supply duct
12″ x 8″ second floor return duct
10″ x 8″ first floor heating/cooling supply duct
Eight 3″ round fresh air supply ducts
Eight 3″ round stale air exhaust ducts
Key to fully utilizing the space has been the interactive staging of work. Today, I installed eight fresh air ducts (white tubes). Next, the HVAC contractor will complete the horizontal section of the supply duct. Then, I will run additional round ducts in the 2×4 bay on the near side. Any other order of work would preclude this degree of packing density.
Jeanine prepared this Swedish almond torte for a dinner party we held this evening. Our guests included two couples with whom we have a great deal in common but have not thus far spent much time together. The company was wonderful and the food delicious. It made for a very relaxing evening after a second day of back-breaking work running ventilation tubes at the River House.
Kyle spent the entire day helping me install the ventilation tubes that will supply fresh air to the River House. In total, the project requires some 1500 feet of tubing. Kyle’s preferred method for carrying the 150-foot spools struck me as very amusing. By the end of the day, we completed 14 of the 32 runs from various parts of the house to the mechanical room where they will be connected to a Zehnder Comfoair Q600. Pulling these corrugated tubes through the joists and cutouts between floors is some of the most physically tiring work you can imagine. Every muscle in my body is sore from the effort and I imagine Kyle will be moving a little slowly tomorrow as well.
Jeanine is in the final throes of publishing her memoir cookbook. A project 15 years in the making. Someone with early access to the manuscript questioned the amount of salt in the family recipe for Taralli. Determined to catch any errors before going to print, Jeanine prepared a batch to verify the accuracy. I was fortunate to be pulled into the quality control work and can categorically testify that these were the best I have ever had.
I found these pictures on Nico’s Instagram account. He recently started training with CrossFit (“constantly varied functional movement at high intensity”) and competed in his first CrossFit Games, placing 69th worldwide in the Open Division. I am fairly certain he is lifting more weight than I ever could. My dad was an accomplished weightlifter as a young man and would have been so happy to see his grandson performing at this level.
My nephew, Rory, just arrived in Tuscany, Italy where he will be working on an organic farm for the next 3 months. It specializes in producing Parmesan cheese from its cows.
WWOOF is a worldwide effort to link visitors with organic farmers, promote an educational exchange, and build a global community conscious of ecological farming practices. Visitors, or ‘WWOOFers’, share in daily life with their host and learn about organic agriculture while spending about half of each day helping out on a farm.
HVAC work began on the River House today. Many of the needed ducts were assembled and insulated in preparation for placement in the joist bays. Supply register openings were cut through the subfloor in locations that were a necessary compromise between the ideal placement and clearance from floor joists and obstructions below. Based on the pace of work and the size of the team, I suspect the work will be finished rather quickly. I am now on deck for the installation of the ventilation system which I hope to tackle over the weekend if not sooner.
We will be using closed-cell foam for the insulation on the River House. Originally we planned on using 2″ of closed-cell foam with 5.5″ of mineral wool batts. Next, we opted for blown-in cellulose in lieu of mineral wool. Then we switched to open-cell foam over the closed-cell base. Finally, we have decided to use 100% closed-cell foam applied to a thickness of 5 to 5.5 inches yielding an R-value of 40 for the exterior walls. Today, the insulation crew treated areas of the exterior walls that will be difficult to access once all the mechanical systems are installed. This included the vertical chase behind the stairwell and the rim board joists between the basement and first floor. In addition to having the highest R-value/inch of any product on the market, closed cell foam adds a ridiculous amount of strength to the wall structure. It was necessary to heat the interior of the house with propane heaters to ensure proper curing of the foam which went in beautifully and I am very pleased with the results. The green circles are from the openings I cut in the sheathing for the ERV vents. They are taped to the pipes I installed to keep heat in and birds out until the vent caps are installed.
On Monday, we will have selected portions of the River House sprayed with closed-cell foam, the insulation product we will be using throughout. The areas that will be addressed are ones that will become impossible to reach later as more and more of the mechanical infrastructure is put in place (ducts, pipes, vents). Two such vents which I added to the house today are for the ERV (Energy Recovery Ventilator) which is a critical component of a tightly sealed house. It is responsible for continuously bringing fresh air in to replace an equal amount of stale air. The intake and exhaust vents each require a 10-inch pipe placed through the siding of the house. The pipes need to be installed with an exact amount of protrusion from the siding to facilitate the later installation of a vent cap. This is the sort of task that is very difficult to do precisely when working alone but led me to a very clever idea for simplifying the task. I measured and marked the distance from the back face of the sheathing to the end of the tube. I then installed four pop-rivets and left their tails in tact. This gave me four bearing points to register the depth of the tube in the siding while I anchored it in place with screws.
Jeanine flew to Minnesota today so that she could attend the opening night performance of our niece, Rose, in her school’s production of the Lion King. As do all of my brother’s children, she has a beautiful singing voice and played the role of Simba. My brother also had a hand in the production and is said to have constructed the “gorge” scene but I have yet to see any photographic evidence to support this claim.
Jeanine has joined the Board of Directors of Minuteman Arc. The non-profit seeks to improve the lives of children and adults with disabilities by increasing lifelong independence, personal choice, and self-advocacy.
She was recruited for the role when she announced her departure from OpenTable but wanted to give herself some time to decompress before accepting the position.
Minute Man Arc offers a variety of programs and services in three main areas: Early Intervention, Pediatric Services, and Adult Services. Their programs focus on integrating service delivery into local communities, organizations, and employment sources. The agency is committed to “valued inclusion in the community” and makes this happen by creating and nurturing a diverse array of partnerships with community groups, neighbors, state agencies, and other funding sources.
This website is dedicated to sharing, with family and friends, the day-to-day adventures of the Calabria family.
